Brake Pad Wear - DAELIM ROADWIN FI - CATALOG Owner's Manual

INSTALLATION NOTES:
To install the rear wheel, reverse the
removal procedure.
Tighten the axle nut to the specified
torque.
REAR AXLE NUT TORQUE : REAR AXLE NUT TORQUE : 6.0~8.0kgf.m
Adjust the drive chain. (page 39)
CA CAUTION UTION
When installing the wheel, carefully
●
fit the left brake disk between the
brake pads to avoid damaging the
pads.
After installing the wheel, apply the
brake several times and then check if
the wheel rotates freely. Recheck the
wheel if the brake drags or if the wheel
does not rotate freely.
W W W W W ARNING ARNING
If torque wrench was not used for
●
installation, see you authorized dealer
as soon as possible to verify proper
assembly. Improper assembly may lead
to loss of braking capacity.

BRAKE PAD WEAR

Brake pad wear depends upon the severity
of usage, the type of riding, and road
conditions. (Generally, the pads will wear
faster on wet and dirty roads.)
Inspect the pads at each regular
maintenance interval. (page 33)
6.0~8.0kgf.m
[FRONT/REAR BRAKE]
Check the cutout in each pad.
If either pad is worn to the cutout,
replace both pads as a set.
See your authorized Daelim dealer for
this service.
<FRONT BRAKE>
<REAR BRAKE>
43