DAELIM Daystar VL125E Service Manual page 193

Rear Wheel/Rear Brake/Suspension
Check the teeth of the final driven sprocket.
Replace the worn, damaged final driven
sprocket.
WARNING
!
Check the drive chain and drive sprocket at the
same time.
Disassembly
Remove the snap ring and final driven sprocket.
NOTE
Do not disassemble unless replacement.
Check the damper rubber. Replace the faulty,
damaged, worn damper rubber.
Remove the dust seal if it is damaged.
Bearing Replacement
Install the bearing remover into the bearing.
Install the bearing remover shaft at th opposite
position, and remove the wheel bearing by
heating with a hammer.
After removing the distance collar, remove the
other bearing.
NOTE
When taking off the wheel bearding, must be
replaced with the new one.
Tools:
Bearing remover shaft
Remover head
15-4
Good
Snap Ring Snap Ring Snap Ring Snap Ring
Snap Ring Snap Ring Snap Ring Snap Ring
Snap Ring Snap Ring
Snap Ring Snap Ring Snap Ring
Dust Seal Dust Seal Dust Seal Dust Seal
Dust Seal Dust Seal
Dust Seal Dust Seal Dust Seal Dust Seal
Dust Seal Dust Seal Dust Seal
Bad
Driven Sprocket Driven Sprocket Driven Sprocket Driven Sprocket
Driven Sprocket Driven Sprocket
Driven Sprocket Driven Sprocket Driven Sprocket Driven Sprocket
Driven Sprocket Driven Sprocket Driven Sprocket
Damper Rubber Damper Rubber
Damper Rubber Damper Rubber
Damper Rubber Damper Rubber Damper Rubber Damper Rubber
Damper Rubber Damper Rubber Damper Rubber Damper Rubber
Damper Rubber
Damper Rubber Damper Rubber
Damper Rubber Damper Rubber
Damper Rubber Damper Rubber Damper Rubber Damper Rubber
Damper Rubber Damper Rubber Damper Rubber Damper Rubber
Damper Rubber