DAELIM Daystar VL125E Service Manual page 224

IGNITION COIL INSPECTION
Remove the seat
Remove the Fuel Tank
Disconnect the primary circuit.
Measure the ignition coil primary coil
resistance between the ignition coil terminal
and ground.
Standard: (Resistance) 0.73 0.08
(Voltage) Over 100V
Disconnect the spark plug caps from the spark
plugs.
Measure the secondary coil resistance between
the ignition coil and ground.
Standard: 15 1.25
NOTE
Don't measure the secondary coil voltage of
ignition coil.
REPLACEMENT
Disconnect the high tension code from the
plug and clamp. Remove the primary circuit
from the ignition coil. Loosen the two bolts
and remove the ignition coil.
Installation is the reverse order of removal.
The secondary coil resistance might not
measure cause by the high voltage diode inside
the ignition coil.
REPLACEMENT
Disconnect the high tension code from the
plug and clamp. Remove the primary circuit
from the ignition coil. Loosen the two bolts
and remove the ignition coil.
Installation is the reverse order of removal.
23 5
K
Ignition Coil Ignition Coil Ignition Coil Ignition Coil
Ignition Coil Ignition Coil Ignition Coil Ignition Coil
Ignition Coil Ignition Coil
Ignition Coil Ignition Coil Ignition Coil
Spark plug cap Spark plug cap Spark plug cap Spark plug cap
Spark plug cap Spark plug cap
Spark plug cap Spark plug cap Spark plug cap Spark plug cap
Spark plug cap Spark plug cap Spark plug cap
Ignition Coil Ignition Coil
Ignition Coil Ignition Coil
Ignition Coil Ignition Coil Ignition Coil Ignition Coil Ignition Coil Ignition Coil
Ignition Coil Ignition Coil Ignition Coil
Ignition System
18-3