Novell/Netware Parameters - HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual

Table 8-10 IPX/SPX configuration information (continued)
Message
PRIMARY FRAME TYPE
NETWORK
FRAME TYPE
RCVD

Novell/NetWare parameters

Information in this section of the HP Jetdirect configuration page is described in
NetWare configuration information on page
on page 143.
Table 8-11 Novell/NetWare
Message
STATUS
NODE NAME
NETWARE MODE
ENWW
Description
An error code and message is displayed if the print server is not ready. For more
information, see Table 8-14 Error messages on page
Frame type selection.
AUTO SELECT Automatically sense and limit to the first one detected.
EN_8023 Limit to IPX over IEEE 802.3 frames. All others are counted and discarded.
EN_II Limit to IPX over Ethernet frames. All others are counted and discarded.
EN_8022 Limit to IPX over IEEE 802.2 with IEEE 802.3 frames. All others are counted
and discarded.
EN_SNAP Limit to IPX over SNAP with IEEE 802.3 frames. All others are counted and
discarded.
Network column specifies the network number associated with a protocol frame type
used for communication between a server and the HP Jetdirect print server.
UNKNOWN Determining which network number to use.
Frame Type column identifies the frame type used with the associated network number:
EN_8023, EN_8022, EN_II, EN_SNAP. Unless a specific frame type is manually set,
the print server automatically determines the protocol frame type by listening to the
network data. DISABLED
RCVD column displays the packets received for each frame type.
141. For error messages, see
configuration information
Description
Current Novell NetWare configuration status.
READY Print server is awaiting data.
DISABLED Manually disabled.
INITIALIZING Registering the node address or name. Additional status messages might
be displayed.
An error code and message is displayed if the print server is not ready. For more
information, see Table 8-14 Error messages on page
Queue Server Mode
appropriate NetWare file server. The default name is NPIXXXXXX, where XXXXXX is
the last six digits of the LAN hardware (MAC) address.
Remote Printer Mode
Mode used by the HP Jetdirect print server.
QUEUE SERVER Receives data directly from the queue.
REMOTE PRINTER Print server emulates a Novell NetWare remote printer. (The printer
number normally follows this parameter.)
Frame type for that network is manually configured.
Print server name, which must match a valid print server on the
Network printer name. The default name is NPIXXXXXX.
HP Jetdirect configuration page 141
143.
Table 8-11 Novell/
Table 8-14 Error messages
143.