Dlc/Llc Protocol Information; Error Messages - HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual

DLC/LLC protocol information

Information in this section of the HP Jetdirect configuration page is described in
configuration information on page
Table 8-13 DLC/LLC
Message
STATUS:

Error messages

Error codes and messages that might appear in the Status sections of the HP Jetdirect configuration
page are described in
Table 8-14 Error messages
Error Code and Message
02 LAN ERROR - INTERNAL
LOOPBACK
03 LAN ERROR - EXTERNAL
LOOPBACK
05 NO SIGNAL DETECTED
06 ENCRYPTION REQUIRED
07 LAN ERROR - CONTROLLER
CHIP
07 AUTHENTICATION FAILED
08 LAN ERROR - INFINITE
DEFERRAL
08 AUTHENTICATION IN
PROGRESS
09 SCANNING FOR SSID
ENWW
143.
configuration information
Description
Current DLC/LLC protocol status.
READY Print server is awaiting data.
DISABLED Manually disabled.
INITIALIZING
display.
An error code and message is displayed if the print server is not ready. For more
information, see
Table 8-14 Error messages on page
Description
During self-test, an internal loopback test error was detected. The print server might be
faulty. If the error persists, replace the HP Jetdirect print server.
Print server is incorrectly connected to your network or is defective. Make sure it is
correctly attached to your network by checking the cabling and connectors.
(802.11 Wireless, Infrastructure Mode only) The print server did not find an access point
and did not detect a radio signal.
Check for sources of radio signal interference. If possible, elevate the print server or the
external antenna (if applicable). Verify other wireless devices are turned on and located
in wireless signal range of the print server.
Encryption is required on this network, but the encryption settings are incorrect. Check
the encryption settings.
Check the network connections. If they are intact, run the self-test by turning the printer
off, and then on again. If the error persists, replace the HP Jetdirect print server.
Print server could not access the network because of an authentication error. The error
depends on the authentication method used.
Verify the authentication method and settings.
Network congestion problem.
Link-level authentication is in progress.
(802.11 Wireless) The print server is scanning on all channels for devices on the
specified SSID (network name). Check your specified SSID, or check status of the
access point (Infrastructure mode) or other wireless devices.
Registering the node address or name. Additional status messages might
Table 8-14 Error messages on page
143.
HP Jetdirect configuration page 143
Table 8-13 DLC/LLC
143.