Limitations To Rules, Templates And Services - HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual

Enter up to ten rules, each rule specifying the host addresses, services, and the action to take for those
addresses and services. Depending on whether IPsec is supported by the print server and device, the
following actions are available:
●
Allow traffic. If IPsec/Firewall is supported, allow IP traffic that is not protected by the IPsec/Firewall
policy.
●
Drop traffic. Do not process (discard) the specified IP traffic.
●
Require traffic to be protected with the IPsec/Firewall policy. You are prompted to configure an
IPsec template indicating the IPsec authentication/encryption settings to apply to the specified IP
traffic.
See the following illustration.
Figure 5-3 Use the IPsec Wizard to configure rules
HP Jetdirect
IPsec/Firewall Policy
IPsec/Firewall Rules

Limitations to rules, templates and services

Limitations to rules, templates, and services are summarized in the following table.
Table 5-2 Limitations to rules, templates and services
Item
Maximum number of rules.
Maximum number of Address Templates.
Note the following:
●
All IP Addresses Results in two (2) address template rules. One for all IPv4 addresses, and
another for all IPv6 addresses.
● All non link local IPv6 Results in four (4) address template rules:
◦
:: to FE7F:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF for both local and remote addresses
◦
:: to FE7F:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF for local addresses
FE81:: to FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF for remote addresses
◦ FE81:: to FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF for local addresses,
ENWW
Use the IPsec/Firewall Wizard
to Configure Each Rule
Rule 1
Step 1, select:
Addresses1
Step 1, select:
Rule 2 Addresses2
Step 3, select:
Step 2, select:
Allow, Drop, or
Services1
Protect with IPsec1
Step 2, select:
Services2
Limit
10
8
HP Jetdirect IPsec/Firewall wizard 101
Step 3, select:
Allow, Drop, or
Protect with IPsec2