HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual page 158

Table 8-14 Error messages (continued)
Error Code and Message
4F TFTP REMOTE ERROR
50 TFTP LOCAL ERROR
51 TFTP RETRIES EXCEEDED
52 BAD BOOTP/DHCP REPLY
53 BAD BOOTP TAG SIZE
54 BOOTP/RARP IN PROGRESS
55 BOOTP/DHCP IN PROGRESS
56 DHCP NAK
57 UNABLE TO CONNECT DHCP
SVR
58 POSTSCRIPT MODE NOT
SELECTED
59 INCOMPLETE F/W - MUST
DOWNLOAD
5A TURN PRINTER OFF / ON
5C DHCP BAD REPLY
5D DHCP LEASE DURATION TOO
SHORT
5E DHCP LEASE RELEASED
5F WINS REGISTRATION FAILED
61 AUTO IP CONFIGURED
62 DEFAULT IP CONFIGURED
63 AUTO IP IN PROGRESS
64 INVALID PASSWORD
148 Chapter 8 HP Jetdirect configuration pages
Description
TFTP transfer of the configuration file from the host to the HP Jetdirect print server failed.
The remote host sent a TFTP error packet to the print server.
TFTP transfer of the configuration file from the host to the HP Jetdirect print server failed.
The local print server encountered an inactivity timeout or excessive retransmission
situation.
Retry limit exceeded when transferring the TFTP configuration file from the host to the
HP Jetdirect print server.
Error detected in the BOOTP or DHCP reply received by the HP Jetdirect print server.
The reply contains insufficient data in the UDP datagram for the minimum BOOTP/
DHCP header of 236 bytes, has an operation field that is not BOOTPREPLY(0X02),
has a header field that does not match the print servers hardware address, or contains
a UDP source port that is not the BOOTP/DHCP server port (67/udp).
Tag size in a vendor-specific field in the BOOTP reply is either 0, or greater than the
remaining number of unprocessed bytes in the vendor-specified area.
Print server is obtaining its basic IP configuration information through BOOTP/RARP.
HP Jetdirect print server is obtaining its basic IP configuration information through
BOOTP/DHCP (no errors detected).
Print server received a negative acknowledgement message from the DHCP server in
response to a configuration request.
The HP Jetdirect print server received IP parameters from a DHCP server, but
communication with the server is lost. Check status of the DHCP server.
If an infinite lease is assigned, the print server uses the IP address of the most recent
DHCP server. Operation can degrade until a DHCP server responds.
Printer does not support AppleTalk or AppleTalk extensions.
Currently downloading firmware to the HP Jetdirect print server, or the download did
not complete properly.
Firmware download is complete. Turn the HP Jetdirect print server off and then on.
Bad reply received from the DHCP server. Check your DHCP server settings for this
print server.
DHCP lease times for this print server's TCP/IP configuration settings are too short. Re-
configure the DHCP lease times on the DHCP server.
Lease parameters for DHCP, including the IP address, were released through a manual
configuration method, such as the printer's control panel.
Cannot register the print server's name on the WINS server. Check for duplicate names,
or verify the WINS server configuration.
Cannot retrieve an IP address over the network. The print server defaults to an IP
address using link-local addressing in the form 169.254.x.x.
Cannot retrieve an IP address over the network. The print server defaults to a legacy
IP address 192.0.0.192.
The print server is automatically assigning an IP address using link-local addressing in
the form 169.254.x.x.
An invalid password was specified through TFTP. Verify that the password consists of
a maximum of 16 printable characters.
ENWW