HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual page 62

Table 3-3 Telnet Commands and Parameters (continued)
SNMP Traps
auth-trap
trap-dest
IPX/SPX
ipx-config
ipx-unitname
Address
ipx-frametype
ipx-sapinterval
ipx-mode
ipx-nds-tree
ipx-nds-context
ipx-job-poll
52 Chapter 3 TCP/IP configuration
Send SNMP authentication traps. Authentication traps indicate that an SNMP request was
received, but the community name check failed.
0 Disable.
1 (default) Enable.
Add a host's IP address to the HP Jetdirect print server's SNMP trap destination list. The
list can contain up to six entries. To receive SNMP traps, the listed systems must have a
trap daemon that listens for the traps. The following is the command format:
trap-dest: <ip-address> [community name] [port number]
In the example, <ip-address> is the IP address of the host to receive traps,
[community name] specifies the SNMP community name, and [port number]
identifies the port number to use.
The default community name is public. The default SNMP port number is 162. You must
enter a community name to specify a port number.
To delete the list, set trap destination to zero (trap-dest: 0).
By default, the SNMP trap destination list is empty and the print server does not send
SNMP traps.
IPX/SPX protocol operation on the print server.
0 Disable.
1 (default): Enable.
NOTE: On HP Jetdirect 635n print servers, all network protocols except TCP/IP are
disabled by factory default.
Name assigned to the print server. Enter up to 31 alphanumeric characters. By default,
the name is NPIxxxxxx, where xxxxxx are the last six digits of the LAN hardware address.
(Read-only parameter.) The IPX network and node numbers detected on the network, in
the form <network number>:<LAN hardware address>.
IPX frame type settings available for your print server model: AUTO (default), EN_SNAP,
EN_8022, EN_8023, EN_II. For more information, see
pages on page 129.
Time in seconds that the HP Jetdirect print server waits between service advertising
protocol (SAP) broadcasts on the network. Set from 1 to 3600 seconds.
0: Disable.
60 (default): Enable SAP broadcasts.
(Read-only parameter.) NetWare mode configured on the print server (RPRINTER or
QSERVER).
NDS tree name for the print server. Enter up to 31 alphanumeric characters.
NDS context for the HP Jetdirect print server. Enter up to 256 alphanumeric characters.
Specifies the time interval in seconds that the HP Jetdirect print server waits to check for
print jobs in a print queue. Set from 1 to 255 seconds.
0: Disable.
HP Jetdirect configuration
ENWW