HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual page 51

Telnet command line interface (default)
Using the Telnet command line interface, you can set configuration parameters using the following
procedures:
NOTE: To view supported commands, formats, and parameters, type ?.
To list additional (or advanced) commands, type advanced before entering ?.
To display current configuration information, type /.
1. At the > Telnet prompt, type the following and press Enter:
<command parameter>: <value>
The <command parameter> signifies the configuration parameter, and <value> is the value
assigned to that parameter. Follow each command entry with
See Table 3-3 Telnet Commands and Parameters on page 41
2. Repeat the previous step to set any additional configuration parameters.
3. When you have finished setting the configuration parameters, type exit or quit (depending on
your system).
Indicate whether to save any changes by entering Y (default) for Yes, or N for No.
If you enter save instead of exit or quit, you are not prompted to save settings.
Telnet commands and parameters.
the available Telnet commands and parameters.
NOTE: If a parameter is dynamically provided by a BOOTP or DHCP server, you cannot change its
value unless you set Manual configuration. See the ip-config command.
When you manually set an IP address, you should also re-set the subnet mask and default gateway.
Table 3-3 Telnet Commands and Parameters
Command
Wireless 802.11 Main
network-type
desired-ssid
auth-type
ENWW
Table 3-3 Telnet Commands and Parameters on page 41
Description
802.11g wireless network topology:
Infrastructure: The print server communicates on the network with other wired or wireless
devices through an access point.
Ad Hoc: (default) The print server communicates with other wireless devices directly,
without using an access point.
Service set identifier (SSID), or network name, for the print server. Enter up to 32
alphanumeric characters.
The factory-default SSID is hpsetup in ad hoc mode. Do not use the SSID hpsetup with
the Infrastructure network type.
If the ssid command is issued without an entry (a blank SSID), the desired SSID is assigned
<AUTO>, where it associates with the first network that matches its authentication settings.
Link-based authentication method for the print server (before network use is allowed).
Enter (carriage return).
for configuration parameters.
IPv4 configuration
lists
41