HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual page 35

Table 3-1 Tags supported in a BOOTP/DHCP boot file (continued)
Item
T147
T148
T149
T150
T151
TFTP configuration file entries (IPv4)
To provide additional configuration parameters for your HP Jetdirect print server, such as SNMP or non-
default settings, you can download a configuration file using TFTP. This TFTP configuration file's relative
path name is specified in the BOOTP reply using the /etc/bootptab file's T144 vendor-specific tag,
or the ef standard BOOTP tag entry. The following is an example of a TFTP configuration file. (The #
symbol signifies a remark and is not included in the file.)
ENWW
RFC 2132 Description
Option
-- Write mode. HP proprietary. Set the TCP PSH flag for device-to-client data transfers.
0 (default): Disable.
1: Set the TCP PSH (all-push) in all data packets.
-- IP gateway disable. HP proprietary. Control configuration of a Gateway IP address.
0 (default): Allow configuration of an IP address.
1: Prevent configuration.
-- Interlock mode. HP proprietary. Require an acknowledgement (ACK) on all TCP packets
before allowing the printer to close a port 9100 print connection. Specify a port number and
option, as in the following example:
<Port Number> <Option>
<Port Number>: For supported HP Jetdirect print servers, the default port number is 1.
<Option>: Set to 0 (default) to disable interlock, or 1 to enable.
For example, setting this to "1 1" specifies port number 1 and enables interlock.
-- TFTP server's IP address. HP proprietary. Specify the IP address of the TFTP server where
the TFTP configuration file is located.
-- Network configuration. HP proprietary. Send either BOOTP-ONLY or DHCP-ONLY
requests.
IPv4 configuration 25