HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual page 57

Table 3-3 Telnet Commands and Parameters (continued)
addq
deleteq
defaultq
addstring
deletestring
TCP/IP Raw Print Ports
raw-port
TCP/IP Access Control
allow
TCP/IP Other
syslog-config
syslog-svr
syslog-max
syslog-priority
ENWW
Add a user-defined queue. Specify the queue name, prepend string name, append string
name, and the processing queue (typically, RAW) in the command line. Enter up to 32
alphanumeric characters. Add up to six user-defined queues.
CAUTION: Do not use lowercase and uppercase characters to differentiate queue
names. Management of LPD queues by other tools can cause unpredictable results.
Set a user-defined deletion queue. Specify the queue name in the deleteq command
line.
Set the queue name to use when the specified queue for a print job is unknown. The default
queue name is AUTO.
Specify a user-defined character string to prepend or append to print data. You can add
up to eight character strings. Specify the string name and the character string in the
addstring command line.
Set a user-defined deletion string. Specify the string name in the deletestring
command line.
Additional ports for printing to TCP port 9100. Valid ports are application dependent and
range between 3000 to 9000. You can add up to two ports.
Add an entry into the host access list stored on the HP Jetdirect print server. Each entry
specifies a host or network of hosts allowed to connect to the printer. The format is allow
netnum [mask] where netnum is a network number or host IP address, and mask is an
address mask of bits applied to the network number and host address to verify access.
Add up to 10 access list entries. If there are no entries, all hosts are permitted access. The
following are some example settings:
allow 192.0.0.0 255.0.0.0 Allows hosts on network 192.
allow 192.168.1.2 Allow a single host. The default mask 255.255.255.255 is
assumed and is not required.
allow 0 Clear the host access list.
For additional information, see
Allow syslog server operation on the print server (UDP port 514).
0: Disable.
1 (default): Enable.
IPv4 address of the server that the HP Jetdirect server sends syslog messages to. For
example:
syslog-svr: 192.168.40.1
Maximum number of syslog messages the HP Jetdirect print server can send per minute.
0: Disable. The number of syslog messages is not restricted.
10 (default): Enable.
Filter syslog messages sent to the syslog server. The filter range is from 0 to 7, with 0
being the most specific and 7 the most general. Only messages that are lower than the
specified filter level (or higher in priority) are reported.
Security features (V.38.xx) on page 113.
IPv4 configuration 47