HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual page 65

Table 3-3 Telnet Commands and Parameters (continued)
network-select
link-type
usb-mode
usb-speed
status-page-lang
ENWW
(For HP Jetdirect products with a dual wired/wireless port. Specifies the active behavior of
the print server.)
● Auto (default): Automatically detects whether a network cable is attached. If a
network cable is not attached, only the IEEE 802.11g wireless port is active. If a
network cable is attached, then only the IEEE 802.3 wired port is active.
CAUTION: Do not plug a network cable into an active wired/wireless port if the
network-select command is set to Auto. Wireless access will immediately terminate.
● Wired: Only the 802.3 wired port is active.
●
Wireless: Only the 802.11g wireless port is active.
(For wired 10/100/1000T Ethernet.) Set the print server's link speed (10, 100, 1000 Mbps)
and communication mode (Full- or Half-Duplex). The available link-speed depends on the
print server model. Select from the following communication modes:
AUTO (default): Use auto-negotiation to configure the highest link speed and
communication mode allowed.
1000FULL: 1000 Mbps, full-duplex operation.
100AUTO: Limit auto-negotiation to a maximum link speed of 100 Mbps.
100FULL: 100 Mbps, full-duplex operation.
100HALF: 100 Mbps, half-duplex operation.
10FULL: 10 Mbps, Full-duplex operation.
10HALF: 10 Mbps, half-duplex operation.
Communication mode over the USB port on the HP Jetdirect print server.
●
Auto (default): Automatically negotiate and set the highest communication mode
possible for the attached printer or device.
● MLC: HP proprietary (multiple logical channels) mode that allows multiple channels
of simultaneous print, scan, and status communication.
● BIDIR: Standard connection that supports bi-directional communication between the
printer and print server.
●
UNIDIR: Standard connection in which data is transferred in one direction only (to
the printer).
(Read-only parameter, USB 2.0 products only.) Auto-negotiated communication speed
over the USB connection between the HP Jetdirect print server and the device.
● Full Speed: 12 Mbits/sec as specified in the USB v2.0 specifications, compatible
with USB v1.1 specifications.
●
Hi-Speed: 480 Mbits/sec for USB v2.0 devices only.
●
Disconnected: USB port is not connected.
Printer job language (PJL) that the print server uses to send the HP Jetdirect configuration/
status page to the printer.
● Auto (default): PJL is auto-detected when the print server is turned on or after a cold-
reset.
●
PCL: HP Printer Control Language
●
ASCII: Standard ASCII characters
IPv4 configuration 55