Security Settings - HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual

Table 8-4 802.11 Wireless settings (continued)
Message
Access Point / BSSID
Channel
Encryption Type

Security Settings

Information in this section of the HP Jetdirect configuration page is described in the following table.
Table 8-5 Security Settings
Message
802.1X
IPsec
or
Firewall
ENWW
Description
No Signal: Level 0 (No radio signal detected on any channel)
<blank>: No radio signal detected while the print server is scanning.
Not Applicable: Signal strength is not applicable when the print server is in ad hoc mode.
Basic service set identifier (BSSID) is a 6-byte number that distinguishes one wireless
LAN (WLAN) from another, even if they have the same network name (SSID).
Infrastructure Mode: The MAC address or name of the access point to which the
HP Jetdirect wireless print server is connected.
Ad Hoc Mode: A random number or name generated by the initiator of the ad hoc
network.
Radio frequency channel that the print server sensed and configured for communication
on the network. Because it was automatically sensed from the network, this channel
can be different than the user-configured channel, which is only used for broadcasts if
the specified network/SSID is not found.
Channel number values 1 through14 might display. The allowed channels are country/
region-dependent.
Specifies the level of encryption configured on the HP Jetdirect print server.
No Security (Open System): Positive validation of a device's identification is not required
for network access unless the network requires EAP authentication. An authentication
failure can indicate that an EAP authentication server has rejected network access.
WEP: Each device on the network is configured with a shared secret WEP key which
is required to gain access to the network. Authentication failures for the HP Jetdirect
print server can arise if the installed key is faulty, or the wrong key is active, when
multiple keys are configured and stored on the print server.
WPA: For enhanced security, Wi-Fi protected access using a pre-shared key is
configuredd. The pre-shared key is generated by the print server through a user-
specified network passphrase configured on the print server.
Description
Indicates which EAP/802.1X client authentication setting was selected.
EAP-TLS Use EAP-TLS.
EAP-PEAP Use EAP-PEAP.
Specified An 802.1X authentication protocol other than EAP-TLS/EAP-PEAP was
selected.
Not Specified No 802.1X authentication was selected.
If the print server and printer/MFP device supports IPsec, then
is not supported, then Firewall
Current IPsec/Firewall status.
Enabled IPsec/Firewall is enabled and operating as configured.
appears.
HP Jetdirect configuration page 135
IPsec appears. If IPsec