HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual page 39

Table 3-2 TFTP configuration file parameters (continued)
syslog-max:
Maximum number of syslog messages sent by the HP Jetdirect print server on a per-minute basis. Allows administrators
to control the log file size. 0: No restriction on the number of messages. 10 (default): Send a maximum of 10 messages
per minute.
syslog-priority:
Filter messages sent to the syslog server. The filter range is 0 to 7, with 0 being the most specific, and 7 the most general.
Only messages that are lower than the specified filter level (or higher in priority) are reported. 7 (default): Messages of all
priorities are sent. 8: Disable. No syslog messages are sent.
syslog-facility:
Identify the source facility of a message. Typically used to identify the source of selected messages during troubleshooting.
By default, the HP Jetdirect print server uses LPR as the source facility code. Use values of local0 through local7 to
isolate individual or groups of print servers.
slp-config:
Use the service location protocol (SLP) operation on the print server. 0: Disable. 1 (default): Enable.
slp-keep-alive:
Number of minutes the print server waits between sending multicast packets on the network to prevent deletion from
network device tables. The range is 1 to 1440 minutes. Some infrastructure devices, such as switches, delete active
devices from their device tables because of network inactivity. 0: Disable.
ttl-slp:
IP multicast time to live (TTL) setting for SLP packets. The range is 1 to 15 hops. (A hop is the number of routers from the
local network.). -1: Disable. 4 (default): Enable.
bonjour-config:
Use Bonjour. (Previously listed as multicast domain name system [mDNS services.) Bonjour is typically used for IP address
and name resolution (through UDP port 5353) where a conventional DNS server is neither used or available. 0: Disable.
1 (default): Enable.
bonjour-service-name:
Bonjour service name. This name is persistent and is used to resolve a particular device or service if socket information
(such as the IP address) changes from session to session. Apple Bonjour displays this service. The default service name
is the printer model and the LAN hardware (MAC) address. Enter up to 64 alphanumeric characters.
bonjour-pri-svc:
Highest priority Bonjour service to use for printing. Set this using the following values:
1: Port 9100 printing
2: IPP port printing
3: Default LPD raw queue
4: Default LPD text queue
5: Default LPD auto queue
6: Default LPD binps (binary PostScript) queue
7 through 12: If user-specified LPD queues are defined, corresponds to user-specified LPD queues 5 through 10.
The default selection depends on the printer, typically port 9100 printing or LPD binps.
ENWW IPv4 configuration 29