Configure A Network Printer For Windows 2000/Server 2003 Systems - HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual

Windows 2000 Click Start, Settings, Control Panel. Then, double-click the Network and
Dial-up Connections folder. Double-click the Local Area Connection for your network and
click Properties.
Server 2003 Click Start, All Programs, Accessories, Communications, and open the
Network Connections folder. Double-click the Local Area Connection for your network and
click Properties.
If Internet Protocol (TCP/IP) is listed and enabled in the list of components used by this
connection, the necessary software is installed. Proceed to
Windows 2000/Server 2003 systems on page
2. If you have not previously installed the software:
●
Windows 2000/Server 2003—In the Local Area Connection Properties window, click
Install. In the Select Network Component Type window, select Protocol and click Add to
add the Internet Protocol (TCP/IP).
Follow the on-screen instructions.
3. Enter TCP/IP configuration values for the computer:
●
Windows 2000/Server 2003—On the General tab in the Local Area Connection
Properties window, select Internet Protocol (TCP/IP) and click Properties.
If you are configuring a Windows server, type the IP address, default gateway address, and subnet
mask in the appropriate spaces.
If you are configuring a client, verify with your network administrator whether to enable automatic
TCP/IP configuration or enter a static IP address, default gateway address, and subnet mask in
the appropriate spaces.
4. Click OK to exit.
5. If prompted, exit Windows and restart your computer for the changes to take effect.

Configure a network printer for Windows 2000/Server 2003 systems

Set up the default printer by performing the following steps.
1. Verify that the Print Services for Unix is installed (required for LPR port availability):
a. On Windows 2000, click Start, Setup, and Control Panel. Double-click the Network and
Dial-up Connections folder.
On Server 2003, click Start, All Programs, Accessories, Communications, and open the
Network Connections folder.
b. Click the Advanced menu and then select Optional Networking Components.
c. Select and enable Other Network File and Print Services.
d. Click Details, and verify that Print Services for Unix is enabled.
e. Click OK, and then Next.
2. On Windows 2000, open the Printers folder (click Start, Settings, and Printers).
On Server 2003, open the Printers and Faxes folder (click Start, Printers and Faxes).
ENWW
Configure a network printer for
161. Otherwise, continue with step 2.
LPD setup overview 161