Command Line Interface; Run The System Setup Wizard - Cisco M190 Quick Start Manual

Command-Line Interface

Run the System Setup Wizard

The hostname parameter is assigned during system setup. Before you
Note
can connect to the web interface using a hostname (http://hostname),
you must add the appliance hostname and IP address to your DNS
server.
Click Login.
Step 3
Access the command-line interface locally or remotely:
Step 1
To access the CLI locally, set up a terminal to connect to the serial
•
port using 9600 bits, 8 bits, no parity, 1 stop bit (9600, 8, N, 1) and
flow control set to Hardware. To physically connect the terminal,
see the "Connect to the Appliance" section on page
To access the CLI remotely, initiate an SSH session to the IP address
•
192.168.42.42.
Log in as admin with the password ironport.
Step 2
At the prompt, run the systemsetup command.
Step 3
Run the System Setup Wizard to configure basic settings and enable a set of
system defaults. The System Setup Wizard starts automatically when you access
the appliance via the web-based interface (or when you run the systemsetup
command from the command-line interface.)
Accept the end user license agreement.
Step 1
Enter system and network information from the
Step 2
section on page
If you need additional information about the settings, choose Help and
Support > Online Help.
3.
7).
"Plan the Installation"
9