Example Tftp Download Procedures - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Chapter 29 Working with System Software Images
Note
The switch downloads the image file from the TFTP server, and the image is copied to the bootflash.
Note
Modify the BOOT environment variable using the set boot system flash device:filename prepend
Step 4
command, so that the new image boots when you reset the switch. Specify the Flash device (device:) and
the filename of the downloaded image (filename).
Step 5 Reset the switch using the reset system command. If you are connected to the switch through Telnet,
your Telnet session disconnects.
Step 6 When the switch reboots, enter the show version command to check the version of the code on the
switch.
For examples that show complete TFTP download procedures for the various supervisor engine and
Note
switch types, see the

Example TFTP Download Procedures

For a step-by-step procedure for downloading a supervisor engine software image from a TFTP server,
Note
see the
This example shows a complete TFTP download procedure of a supervisor engine software image:
Console> (enable) show version 1
Mod Port Model
--- ---- ---------- -------------------- ---------------------------------
1
Console> (enable) copy tftp flash
IP address or name of remote host []? 172.20.52.3
Name of file to copy from []? cat4000.6-1-1.bin
Flash device [bootflash]?
Name of file to copy to [cat4000.6-1-1.bin]?
4369664 bytes available on device bootflash, proceed (y/n) [n]? y
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCC
File has been copied successfully.
Console> (enable) set boot system flash bootflash:cat4000.6-1-1.bin prepend
BOOT variable = bootflash:cat4000.6-1-1.bin,1;bootflash:cat4000.4-1-2.bin,1;
Console> (enable) reset system
This command will reset the system.
Do you want to continue (y/n) [n]? y
Console> (enable) 07/21/2000,13:51:39:SYS-5:System reset from Console//
System Bootstrap, Version 3.1(2)
78-12647-02
The Catalyst 4000 family, 2948G, and 2980G switches have only one Flash device (bootflash).
The switch remains operational while the image downloads.
"Example TFTP Download Procedures" section on page
"Downloading Supervisor Engine Images Using TFTP" section on page
Serial #
0 WS-X4012 JAB03130104
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
Downloading System Software Images to the Switch Using TFTP
Versions
Hw : 1.5
Gsp: 6.1(1.4)
Nmp: 6.1(0.104)
29-3.
29-2.
29-3