Chapter 14
Configuring QoS
Enabling QoS Globally
To enable QoS globally on the switch, perform this task in privileged mode:
Task
Enable QoS on the switch.
This example shows how to enable QoS:
Console> (enable) set qos enable
QoS is enabled.
Console> (enable)
Configuring the Default CoS Value for the Switch
QoS assigns unclassified frames received on any port on the switch that the CoS value configured for the
switch. The default CoS value is zero.
To set the default CoS value, perform this task in privileged mode:
Task
Step 1
Set the CoS value for the switch.
Step 2
Verify the CoS value of the switch.
This example shows how to set CoS equal to 7 in all unclassified frames received on the switch and
verify the configuration:
Console> (enable) set qos defaultcos 7
qos defaultcos set to 7
Console> (enable)
Reverting to the Default Switch CoS Value
To revert to the default switch CoS value, perform this task in privileged mode:
Task
Step 1
Revert to the default CoS value for the switch.
Step 2
Verify that the default CoS value was restored.
This example shows how to revert to the default CoS value for port 8/1 and verify the configuration:
Console> (enable) clear qos defaultcos
qos defaultcos setting cleared.
Console> (enable)
78-12647-02
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
Command
set qos enable
Command
set qos defaultcos cos-value
show qos info [runtime | config]
Command
clear qos defaultcos
show qos info [runtime | config]
Configuring QoS
14-5