Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual page 24

Organization
Chapter
Part 3—Spanning Tree
Chapter 7
Chapter 8
Part 4—Configuring VLANs and VLAN Trunks
Chapter 9
Chapter 10
Chapter 11
Chapter 12
Chapter 13
Part 5—Directing and Filtering Traffic
Chapter 14
Chapter 15
Chapter 16
Chapter 17
Chapter 18
Part 6—Monitoring and Managing the Switch
Chapter 19
Chapter 20
Chapter 21
Chapter 22
Chapter 23
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
xxiv
Title
Configuring Spanning Tree
Configuring Spanning Tree
PortFast, UplinkFast, and
BackboneFast, and Loop Guard
Configuring VTP
Configuring VLANs
Configuring VLAN Trunks on
Fast Ethernet and Gigabit
Ethernet Ports
Configuring Dynamic Port
VLAN Membership with VMPS
Configuring GVRP
Configuring QoS
Configuring Multicast Services
Configuring Port Security
Configuring the IP Permit List
Configuring Protocol Filtering
Checking Port Status and
Connectivity
Configuring CDP
Using Switch TopN Reports
Configuring UDLD
Configuring SNMP
Description
Describes how to configure the Spanning Tree
Protocol and explains how spanning tree works.
Describes how to configure the spanning tree
PortFast, UplinkFast, and BackboneFast features.
Describes how to configure VLAN Trunk Protocol
(VTP) on the switch.
Describes how to configure VLANs and private
VLANs on the switch.
Describes how to configure Inter-Switch Link (ISL)
and IEEE 802.1Q VLAN trunks on Fast Ethernet and
Gigabit Ethernet ports.
Describes how to configure VLAN Membership
Policy Server (VMPS) and dynamic ports on the
switch.
Describes how to configure GARP VLAN
Registration Protocol (GVRP) on the switch.
Describes how to configure quality of service (QoS).
Describes how to configure Cisco Group
Management Protocol (CGMP), Internet Group
Management Protocol (IGMP) snooping, and GARP
Multicast Registration Protocol (GMRP) on the
switch.
Describes how to configure port security on the
switch.
Describes how to configure IP permit list on the
switch.
Describes how to configure protocol filtering on
Ethernet, Fast Ethernet, and Gigabit Ethernet ports.
Describes how to display information about modules
and switch ports and how to check connectivity using
ping, Telnet, and IP traceroute.
Describes how to configure Cisco Discovery
Protocol (CDP) on the switch.
Describes how to generate switch TopN reports on
the switch.
Describes how to configure the UniDirectional Link
Detection (UDLD) protocol on the switch.
Describes how to configure the Simple Network
Management Protocol (SNMP) on the switch.
Preface
78-12647-02