Chapter 15
Configuring Multicast Services
•
•
GMRP Software Requirements
GMRP requires supervisor engine software release 5.1 or later releases.
Default GMRP Configuration
Table 15-2
Table 15-2 GMRP Default Configuration
Feature
GMRP enable state
GMRP per-port enable state
GMRP forward all
GMRP registration
GARP/GMRP timers
Enabling GMRP Globally
Note
You cannot enable GMRP if CGMP is enabled.
To enable GMRP globally, perform this task in privileged mode:
Task
Step 1
Enable GMRP on the switch.
Step 2
Verify the configuration.
This example shows how to enable GMRP and verify the configuration:
Console> (enable) set gmrp enable
GMRP enabled.
Console> (enable) show gmrp configuration
Global GMRP Configuration:
GMRP Feature is currently enabled on this switch.
GMRP Timers (milliseconds):
Join = 200
Leave = 600
LeaveAll = 10000
Port based GMRP Configuration:
78-12647-02
Clearing GMRP Statistics, page 15-15
Disabling GMRP on the Switch, page 15-15
shows the default GMRP configuration.
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
Default Value
Disabled
Disabled
Disabled on all ports
Normal on all ports
Join time: 200 ms
•
•
Leave time: 600 ms
•
Leaveall time: 10,000 ms
Command
set gmrp enable
show gmrp configuration
Configuring GMRP
15-9