Setting The Radius Timeout Interval; Setting The Radius Retransmit Count - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Configuring Authentication

Setting the RADIUS Timeout Interval

You can specify the timeout interval between retransmissions to the RADIUS server. The default timeout
is 5 seconds.
To specify the RADIUS timeout interval, perform this task in privileged mode:
Task
Step 1
Configure the RADIUS timeout interval.
Step 2 Verify the RADIUS configuration.
This example shows how to specify the RADIUS timeout interval and verify the configuration:
Console> (enable) set radius timeout 10
Radius timeout set to 10 seconds.
Console> (enable) show radius
Login Authentication:
---------------------
tacacs
radius
local
Enable Authentication: Console Session
---------------------- ----------------- ----------------
tacacs
radius
local
Radius Deadtime:
Radius Key:
Radius Retransmit:
Radius Timeout:
Radius-Server
----------------------------- -------
172.20.52.3
Console> (enable)

Setting the RADIUS Retransmit Count

You can specify the number of times the switch will attempt to contact a RADIUS server before the next
configured server is tried. By default, each RADIUS server will be tried two times.
To specify the RADIUS retransmit count, perform this task in privileged mode:
Task
Step 1 Configure the RADIUS server retransmit count.
Step 2
Verify the RADIUS configuration.
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
27-26
Command
set radius timeout seconds
show radius
Console Session Telnet Session
---------------- ----------------
disabled disabled
enabled(primary) enabled(primary)
enabled enabled
Telnet Session
disabled disabled
enabled(primary) enabled(primary)
enabled enabled
0 minutes
Secret_RADIUS_key
2
10 seconds
Status Auth-port
------------
primary 1812
Command
set radius retransmit count
show radius
Chapter 27 Configuring Switch Access Using AAA
78-12647-02