Updating The Server; Suppressing Accounting; Configuring Accounting; Accounting Default Configuration - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Configuring Accounting

local
Radius Deadtime:
Radius Key:
Radius Retransmit:
Radius Timeout:
Radius-Server
----------------------------- -------
172.20.52.3
Console> (enable)

Updating the Server

You can configure the switch to send accounting information to the TACACS+ server. There are two
options:
•
•

Suppressing Accounting

You can configure the system to suppress accounting when an unknown user with no username accesses
the switch by using the set accounting suppress null-username enable command.
Note RADIUS and TACACS+ accounting are the same, except that RADIUS does not do command
accounting, periodic updates, or allow null-username suppression.
Configuring Accounting
These sections describe how to configure accounting for both TACACS+ and RADIUS:
•
•
•

Accounting Default Configuration

Table 27-5
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
27-58
enabled(primary)
Newinfo—Sends accounting information to the server only when new accounting information
becomes available.
Periodic—Sends accounting update records at regular intervals. This option can be used to keep
up-to-date connection and session information even if the NAS restarts and loses the initial start
time. You must set a time lapse between periodic updates. Valid intervals are from 1 to
71582 minutes.
Accounting Default Configuration, page 27-58
Accounting Configuration Guidelines, page 27-59
Configuring Accounting, page 27-59
shows the default accounting configuration.
Chapter 27
enabled(primary)
0 minutes
2
5 seconds
Status Auth-port
------------
primary 1812
Configuring Switch Access Using AAA
78-12647-02