Table of Contents
Advertisement
Configuring SPAN and RSPAN
This chapter describes how to configure the Switched Port Analyzer (SPAN) and Remote SPAN
(RSPAN) on the Catalyst 4000 family switches.
Note
For complete syntax and usage information for the commands used in this chapter, refer to the Command
Reference—Catalyst 4000 Family, Catalyst 2948G, and Catalyst 2980G Switches.
This chapter consists of these major sections:
•
•
•
•
To configure SPAN or RSPAN from a network management station (NMS), refer to the NMS
Note
documentation (see the
Understanding How SPAN and RSPAN Work
The following sections describe the concepts and terminology associated with SPAN and RSPAN
configuration.
SPAN Session
A SPAN session is an association of a destination port with a set of source ports, configured with
parameters that specify the monitored network traffic. You can configure multiple SPAN sessions in a
switched network. SPAN sessions do not interfere with the normal operation of the switches. You can
enable or disable SPAN sessions with command-line interface (CLI) or SNMP commands. When
enabled, a SPAN session might become active or inactive based on various events or actions that would
be indicated by a syslog message. The "Status" field in the show span and show rspan commands
displays the operational status of a SPAN or RSPAN session.
After the system is on, a SPAN or RSPAN destination session remains inactive until the destination port
is operational. An RSPAN source session remains inactive until any of the source ports are operational
or the RSPAN VLAN becomes active.
78-12647-02
Understanding How SPAN and RSPAN Work, page 25-1
SPAN and RSPAN Session Limits, page 25-4
Configuring SPAN, page 25-4
Configuring RSPAN, page 25-8
"Using CiscoWorks2000" section on page
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
C H A P T E R
23-13).
25
25-1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
