Disabling Tacacs+ Directed Request; Clearing Tacacs+ Servers - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Chapter 27 Configuring Switch Access Using AAA
This example shows how to enable TACACS+ directed request and verify the configuration:
Console> (enable) set tacacs directedrequest enable
Tacacs direct request has been enabled.
Console> (enable) show tacacs
Tacacs key: Secret_TACACS_key
Tacacs login attempts: 5
Tacacs timeout: 30 seconds
Tacacs direct request: enabled
Tacacs-Server
----------------------------------------
172.20.52.3
172.20.52.2
172.20.52.10
Console> (enable)

Disabling TACACS+ Directed Request

To disable TACACS+ directed request, perform this task in privileged mode:
Task
Step 1
Disable TACACS+ directed request on the switch. set tacacs directedrequest disable
Step 2
Verify the TACACS+ configuration.
This example shows how to disable TACACS+ directed request:
Console> (enable) set tacacs directedrequest disable
Tacacs direct request has been disabled.
Console> (enable)

Clearing TACACS+ Servers

To clear one or more TACACS+ servers, perform this task in privileged mode:
Task
Step 1
Specify the IP address of the TACACS+ server to
clear from the configuration. Use the all keyword
to clear all of the servers from the configuration.
Step 2
Verify the TACACS+ server configuration.
This example shows how to clear a specific TACACS+ server from the configuration:
Console> (enable) clear tacacs server 172.20.52.3
172.20.52.3 cleared from TACACS table
Console> (enable)
This example shows how to clear all TACACS+ servers from the configuration:
Console> (enable) clear tacacs server all
All TACACS servers cleared
Console> (enable)
78-12647-02
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
Status
-------
primary
Command
show tacacs
Command
clear tacacs server [ip_addr | all]
show tacacs
Configuring Authentication
27-21