Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual page 55

If you are using an ISO image rather than a physical media, copy the ISO to a temporary folder
on the Linux device, then mount the image using the following command:
mount -o loop /tempfolderpath/isoimagename.iso mountpoint
Replace tempfolderpath with the path to the temporary folder and replace mountpoint with the
path to the file system location you want to mount the image. The path specified by mountpoint
must already exist.
For example:
mount -o loop /zlm7/ZENworks_Agent.iso /zlm/install
3 Log in as root, then start the installation program:
For Workstations and Servers that are Not Dell PowerEdge Servers: If you are
installing the ZENworks Agent on a workstation or a server that you do not want to
manage using the ZENworks Linux Management features specific to PowerEdge servers
(on a server that is not a Dell PowerEdge server, for example), start the installation from
the mount point using the following command:
./zlm-install -a
The option installs only agent portions of ZENworks Linux Management. The
-a
option is optional because the agent iso, however, installs only the agent component.
For Dell PowerEdge Servers: If you are installing the ZENworks Agent on a Dell
PowerEdge server that you want to manage using the ZENworks Linux Management
features specific to PowerEdge servers, start the installation program from the mount point
using the following command:
./zlm-install -o
The option installs the OEM module for Dell hardware required to use the features
-o
specific to Dell PowerEdge servers in ZENworks Linux Management.
If you install the ZENworks Agent using the
Linux Management Dell functionality until you have completed the configuration steps in
Section 7.4, "Enabling Dell PowerEdge Support," on page
NOTE: The steps in this procedure perform a standard installation of ZENworks Linux
Management. Depending on your situation, additional options can be used with the
command. For more information, see
install
page 117.
If you do not have the X Window System installed (for example, you installed a Minimal
installation of SUSE Linux Enterprise Server 9), see
4 When prompted to install ZENworks, enter
5 Review the Software License Agreement, pressing Page Down to scroll down the page, then
enter to accept the agreement.
Y
Installation of the ZENworks Agent software begins.
After the ZENworks Agent software installation is complete, do the following:
If you are installing the ZENworks 7.2 Linux Management Agent, skip to
If you are installing the ZENworks 7.2 Linux Management with IR1/IR1a/IR2 Agent,
continue with Step
Section A.1, "Installation Options," on
to continue.
Y
6.
option, you cannot use the ZENworks
-o
59.
"-x" on page 118.
Setting Up Managed Devices
-a
zlm-
Step 7.
55