Performing An In-Place Upgrade On A Zenworks Secondary Server - Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual

4 When prompted to upgrade ZENworks Linux Management, enter
5 Review the Software License Agreement, pressing Page Down to scroll down the page, then
enter to accept the agreement.
Y
6 Enter
when you are asked if you are upgrading a ZENworks Primary Server.
Y
Make sure all ZENworks services on secondary servers are stopped. You can execute
novell/zenworks/bin/zlm-config --stop
servers.
7 Press Enter to continue.
The upgrade program stops ZENworks services, subscribes to the upgrade channels, upgrades
RPMs, upgrades zmd, runs upgrade scripts, and then upgrades the database schema.
8 Enter the ZENworks administrator password.
The ZENworks services are restarted.
9 When prompted to create bundles that can be used to upgrade zlm clients (managed devices),
enter to continue.
Y
If you choose to not create upgrade bundles at this time, you can execute the
command using the ZENworks 7.2 Linux Management Agent CD at a later time to create the
bundles.
10 Specify a folder that you want to create to hold the upgrade bundles.
11 After the upgrade completes, refer to /
to ensure that the upgrade is successful.
12 (Conditional) If you have ZENworks Secondary Servers to upgrade, continue with
an In-Place Upgrade on a ZENworks Secondary Server" on page
13 Continue with "Upgrading Managed Devices Manually" on page
or
Continue with "Upgrading Managed Devices by Using Upgrade Bundles" on page
11.1.2 Performing an In-Place Upgrade on a ZENworks
Secondary Server
You must upgrade the ZENworks Primary Server before upgrading ZENworks Secondary Servers.
For step-by-step information, see
Server" on page 84.
1 Make sure the server meets the requirements. See
Requirements," on page
2 At the Linux server, mount the Novell ZENworks 7.2 Linux Management Server CD by using
the
mount device mountpoint
For example,
mount /dev/cdrom /zlm72
If you are using an ISO image rather than a physical CD, copy the ISO to a temporary folder on
the Linux server, then mount the image using the following command:
mount -o loop /tempfolderpath/isoimagename.iso mountpoint
Replace tempfolderpath with the path to the temporary folder and replace mountpoint with the
path to the file system location where you want to mount the image. The path specified by
mountpoint must already exist.
to shut down the services on secondary
var/opt/novell/log/zenworks/zlm-upgrade.log
"Performing an In-Place Upgrade on the ZENworks Primary
25.
command.
.
to continue.
Y
85.
86.
Section 2.1, "ZENworks Server
Upgrading to ZENworks 7.2 Linux Management
/opt/
zlm-upgrade -b
"Performing
87.
85