Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual page 43

For more information about installing ZENworks Linux Management on a SUSE Linux
Enterprise Server with a Minimal installation, see
5 When prompted to install ZENworks, enter
6 Review the Software License Agreement, press Page Down to scroll down the page, then enter
to accept the agreement.
Y
Installation of the software begins. There are ten software components to install. Installation
progress is displayed for each component.
If you are installing on a SUSE Linux Enterprise Server 10 (SLES 10) device, a message might
be displayed informing you that some packages are already installed (for example, rug, zmd-
inventory, or zen-updater). Some packages that ship with ZENworks Linux Management also
ship with SLES 10. Depending on the versions of these packages, you might be prompted to re-
install these packages, which might overwrite configuration changes you have made. Press
continue.
7 When installation of the software is complete, enter
ZENworks Primary Server and Management Zone.
8 Provide the appropriate responses to the following prompts:
Is this the first server in your system?: Enter
Enter a unique Management Zone name: Enter the name you want to use for your
ZENworks Management Zone. For example, Novell_Boston. The name cannot be the
same as any other ZENworks Management Zone in your network environment. If you use
Novell eDirectory, it cannot be the same name as your eDirectory tree name.
Enter an Administrator password: Enter the password you want assigned to the default
ZENworks Administrator account.
Repeat the Administrator password: Re-enter the password.
Do you want ZENworks to install and set up a local PostgreSQL database for you?:
If you want to use a new PostgreSQL database for the ZENworks Data Store and have it
located on the Primary Server, enter
or Oracle database, either on the Primary Server or on a remote server, enter
9 If you chose to use an existing database, continue with
or
If you chose to install and set up a local PostgreSQL database, skip to
10 Provide the appropriate responses to the following prompts to configure access to an existing
database:
IP address or hostname of the database server: Enter the IP address or DNS hostname
of the server hosting the database.
Port database is listening on: Enter the listening port being used by the database server.
The default PostgreSQL listening port is 5432. The default Oracle listening port is 1521.
Database name/SID: For a PostgreSQL database, enter the name of the database. For an
Oracle database, enter the SID (System Identifier).
Database user name: Enter the user name for an administrative account that provides full
access to the database.
Database user password: Enter the account password.
"Operating System" on page
to continue.
Y
to run
Y zlm-config
for Yes.
Y
for Yes. If you want to use an existing PostgreSQL
Y
Step 10.
Installing the ZENworks Primary Server
25.
to
Y
and configure the
for No.
N
Step 11.
43