Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual page 42

IMPORTANT: If other services run on port 80, the installation will fail; the server cannot run
other services on port 80. If Apache or another service is binding to port 80, remove the service
or change the service's port.
For example, change the Apache2 web server's Listen Port (on SLES 9 SP3 as found in
apache2/ listen.conf
run zlm-config.
2 (Conditional) If you plan to use an existing database for the ZENworks Data Store, make sure
you've prepared the database. See
Store," on page
3 At the Linux server, mount the product media of the ZENworks Linux Management version
you want to install by using the
Use the Novell ZENworks 7 Linux Management CD to install ZENworks 7 Linux
Management.
Use the Novell ZENworks 7.2 Linux Management Server CD to install ZENworks 7.2
Linux Management.
Use the Novell ZENworks 7.2 Linux Management with Interim Release 1 Server CD to
install ZENworks 7.2 Linux Management with IR1.
Use the Novell ZENworks 7.2 Linux Management with Interim Release 2 Server CD to
install ZENworks 7.2 Linux Management with IR2.
For example, to install ZENworks 7 Linux Management, mount the product media by using
mount /dev/cdrom /zlm7
If you are using an ISO image rather than a physical media, copy the ISO to a temporary folder
on the Linux server, then mount the image using the following command:
mount -o loop /tempfolderpath/isoimagename.iso mountpoint
Replace tempfolderpath with the path to the temporary folder and replace mountpoint with the
path to the file system location you want to mount the image. The path specified by mountpoint
must already exist.
For example:
mount -o loop /zlm7/ZEN7_LinuxMgmt.iso /zlm7/install
4 Log in as
following command:
./zlm-install
NOTE: The steps in this procedure perform a standard installation of ZENworks Linux
Management. Depending on your situation, additional options can be used with the
install
If you do not have the X Window System installed (for example, you installed a Minimal
installation of SUSE
32 bit, and compat-32bit packages to the server before installing ZENworks Linux
Management. When you install ZENworks Linux Management on the server, you must use the
switch to avoid dependency problems. Running
-x
that require the X Window System. In
installation lacks the zmd-gconfpolicyenforcer, novell-zenworks-zmd-rmagent, and vnc
components.
42 Novell ZENworks 7.2 Linux Management Installation Guide
) from 80 to 81. Make sure the Apache service is shut down and then
Section 3, "Preparing the Database for the ZENworks Data
33.
mount device mountpoint
.
, then start the installation program from the mount point by running the
root
command. For more information, see
®
Linux Enterprise Server 9), you need to install the glib2, XFree86-libs-
command.
Appendix VI, "Appendixes," on page
./zlm-install –x
Step 7 below, you must agree when it says that the
/etc/
zlm-
115.
skips any packages