Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual page 50

Installation of the software begins. There are ten software components to install. Installation
progress is displayed for each component.
11 When installation of the software is complete, enter
ZENworks Secondary Server.
12 Provide the appropriate responses to the following prompts:
Is this the first server in your system?: Enter
IP address or DNS name of the primary server: Enter the IP address or DNS name of
the Primary Server.
Is the system clock synchronized with the primary server?: Enter
(Step 1 on page
Administrator Password: Enter the password for the ZENworks Administrator account.
Would you like to continue with installation into the Management Zone?: The
installation program displays the name of the ZENworks Management Zone in which the
Secondary Server will be installed. Enter
The zlm-config utility adds the server to the ZENworks system as a ZENworks Secondary
Server and then configures the ZENworks Server software components.
13 When configuration of the ZENworks Server software components is complete, you should
verify the installation. To do so:
13a Confirm that the ZENworks services are running by using the following command:
/opt/novell/zenworks/bin/zlm-config --status
The screen output should show that all services are running.
log dir: /var/opt/novell/log/zenworks
Novell eDirectory is running
Novell ZENworks Server is running
Novell ZENworks Loader is running
Novell ZENworks Imaging Service is running
Novell ZENworks Preboot Policy Daemon is running
Novell ZENworks Server Management is running
Novell ZENworks Management Daemon is running
If a service is not running, use the following command to start it:
/etc/init.d/servicename start
Replace servicename with the name of the service that needs to be started.
Service
Novell eDirectory
Novell ZENworks Server
Novell ZENworks Loader
Novell ZENworks Imaging Service
Novell ZENworks Preboot Policy Daemon
Novell ZENworks Server Management
Novell ZENworks Management Daemon
50 Novell ZENworks 7.2 Linux Management Installation Guide
48).
to run
Y zlm-config
for No.
N
to continue.
Y
Service Name
ndsd
novell-zenserver
novell-zenloader
novell-pbserv
novell-zmgprebootpolicy
novell-zented
novell-zmd
and configure the
to continue
Y