Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual page 44

11 When configuration of the ZENworks Server components is complete, you should verify the
installation. To do so:
11a Confirm that the ZENworks services are running by using the following command:
/opt/novell/zenworks/bin/zlm-config --status
The screen output should show that all services are running.
Novell ZENworks Imaging Service is running
Novell eDirectory is running
Novell ZENworks Server Management is running
Novell ZENworks Imaging Agent is running
Novell ZENworks Server is running
Novell ZENworks Preboot Policy Daemon is running
Novell ZENworks Management Daemon is running
Novell ZENworks Loader is running
If a service is not running, use the following command to start it:
/etc/init.d/servicename start
Replace servicename with the name of the service that needs to be started.
Service
Novell eDirectory
Novell ZENworks Server
Novell ZENworks Loader
Novell ZENworks Imaging Service
Novell ZENworks Preboot Policy Daemon
Novell ZENworks Server Management
Novell ZENworks Management Daemon
Novell Imaging Agent
For example, if the Novell ZENworks Management Daemon is not running, use the
following command to start it:
/etc/init.d/novell-zmd start
For additional information about the ZENworks services, see
Novell ZENworks 7.27.3 Linux Management Administration
11b (Conditional) If you are using the PostgreSQL database, confirm that it is running by
using the following command at the database server:
/etc/init.d/postgresql status
11c Access the ZENworks Control Center using a Web browser that meets the requirements
listed in
following URL to access the Control Center:
https://ZENworks_Primary_Server_Address
44 Novell ZENworks 7.2 Linux Management Installation Guide
Section 2.4, "Administration Workstation Requirements," on page
Service Name
ndsd
novell-zenserver
novell-zenloader
novell-pbserv
novell-zmgprebootpolicy
novell-zented
novell-zmd
novell-zislnx
"ZENworks
Guide.
Services" in the
29. Use the