Upgrading Managed Devices Manually - Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual

For example:
mount -o loop /zlm72/ZEN72_LinuxMgmt.iso /zlm72/install
3 Log in as
command:
./zlm-upgrade
4 When prompted to upgrade ZENworks Linux Management, enter
5 Review the Software License Agreement, pressing Page Down to scroll down the page, then
enter
The install program stops ZENworks services, subscribes to the upgrade channels, upgrades
RPMs, upgrades zmd, runs upgrade scripts, and then restarts the ZENworks services.
6 Enter
7 Enter
Ignore any "failed to stop" errors that you receive. For example, you receive an error indicating
that eDirectory could not be stopped, but it was already stopped when you executed
novell/zenworks/bin/zlm-config --stop
The upgrade program stops ZENworks services, subscribes to the upgrade channels, upgrades
RPMs, upgrades zmd, and runs upgrade scripts.
After the upgrade is complete, the ZENworks services are restarted. This might take a few
minutes.
8 (Conditional) Repeat
want to upgrade.
9 Continue with
or
Continue with

11.1.3 Upgrading Managed Devices Manually

1 Make sure the managed device meets the requirements. See
Requirements," on page
2 At the Linux managed device, mount the Novell ZENworks 7.2 Linux Management Agent CD
by using the
For example,
If you are using an ISO image rather than a physical CD, copy the ISO to a temporary folder on
the Linux managed device, then mount the image using the following command:
mount -o loop /tempfolderpath/isoimagename.iso mountpoint
Replace tempfolderpath with the path to the temporary folder and replace mountpoint with the
path to the file system location you want to mount the image. The path specified by mountpoint
must already exist.
For example:
mount -o loop /zlm72/ZEN72_LinuxMgmt.iso /zlm72/install
3 Log in as
command:
./zlm-upgrade
86 Novell ZENworks 7.2 Linux Management Installation Guide
, then start the upgrade program from the mount point by running the following
root
to accept the agreement.
Y
when you are asked if you are upgrading a ZENworks Primary Server.
N
when you are asked if you have upgraded the ZENworks Primary Server.
Y
Step 1 through
"Upgrading Managed Devices Manually" on page
"Upgrading Managed Devices by Using Upgrade Bundles" on page
26.
mount device mountpoint
mount /dev/cdrom /zlm72
, then start the upgrade program from the mount point by running the following
root
in Step 6 on page
Step 7 f or each ZENworks Secondary Server that you
Section 2.3, "Managed Device
command.
.
to continue.
Y
/opt/
85.
86.
87.