Installing The Zenworks Server Software As Secondary Server - Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual

6.2 Installing the ZENworks Server Software as
Secondary Server
To install a Secondary Server:
1 Synchronize the Secondary Server's system clock with the Primary Server's system clock to
ensure correct operation of the system. If the two servers are not synchronized, the installation
fails.
After synchronizing the clocks, restart eDirectory and all ZENworks Linux Management
services on the Primary Server. To restart the ZENworks Linux Management services, enter the
following command:
/opt/novell/zenworks/bin/zlm-config --restart
2 From the ZENworks Primary Server that you installed by following the steps in
"Installing the ZENworks Primary Server," on page
zlm-config --allow-secondary=Secondary_Server
where
This command identifies each Secondary Server before it is installed. Repeat this command for
each Secondary Server that you install.
If you are installing to a SUSE Linux Enterprise Server 10 (SLES 10) device, see
"Installing a ZENworks Server on a Device Configured with DHCP," on page
NOTE: If you add a Secondary Server that has a router between it and the Primary Server, you
get the following error message:
The installer was unable to connect to the specified database. Please
verify the values you entered and try again.
Check the
and see which IP address the Primary Server thinks is trying to connect with it. If the address is
the router's address rather than the address of your Secondary Server, you most likely have
masquerading running on the router.
The best solution to remedy this problem is to disable masquerading on the router. You can also
use the router address when specifying the IP or DNS name of the Secondary Server but this
causes potential security risks.
3 When prompted to restart ZENworks, enter
4 Repeat
5 Make sure the intended Secondary Server meets the requirements. See
Server Requirements," on page
IMPORTANT: If other services run on port 80, the installation will fail; the server cannot run
other services on port 80. If Apache or another service is binding to port 80, remove the service
or change the service's port.
For example, change the Apache2 web server's Listen Port (on SLES 9 SP1 as found in
apache2/ listen.conf
run zlm-config.
6 Make sure the Secondary Server's system clock is synchronized with the Primary Server's
system clock.
48 Novell ZENworks 7.2 Linux Management Installation Guide
is the IP address or DNS name of the intended Secondary Server.
Secondary_Server
/var/opt/novell/log/zenworks/zlm-config.log
Step 2 and Step 3 on page 48
) from 80 to 81. Make sure the Apache service is shut down and then
41, and enter the following command:
for Yes.
Y
each Secondary Server that you are installing.
25.
Section 5,
Section A.5,
121.
file on the Primary Server
Section 2.1, "ZENworks
/etc/