Reset Snapshot - HP 2000fc Cli Reference Manual

reset snapshot

Description
Deletes the data in a snapshot and resets it to the current data in the associated
master volume. The snapshot's volume characteristics are not changed. The
command prompts you to unmount the snapshot from the host operating system
before performing the reset; leaving it mounted can cause data corruption.
Caution –
command is lost.
Input
reset snapshot volume [prompt yes|no]
Parameter
volume
prompt yes|no
Example
Reset snapshot SS1.
# reset snapshot SS1
Leaving the snapshot mounted during reset on any operating system
can result in data corruption. Is the snapshot un-mounted from all
operating systems? yes
Success: Snapshot Reset Complete.
Related Commands
"show snapshots" on page 218
■
100 HP StorageWorks 2000 Family Modular Smart Array CLI reference guide • May 2008
All data represented by the snapshot as it exists prior to issuing this
Description
Specifies the volume by its name or serial number. For the
syntax to use, see "Volume Syntax" on page 26.
Optional. Specifies an automatic response to the unmount
prompt that either enables the reset to proceed or prevents the
reset from proceeding:
• yes: Enables the reset to proceed
• no: Prevents the reset from proceeding
If this parameter is omitted, you must reply to the prompt.