Show Debug-Log-Parameters - HP 2000fc Cli Reference Manual

show debug-log-parameters

Description
Note –
advice of a service technician.
Shows which debug message types are enabled (on) or disabled (off) for inclusion
in the Storage Controller debug log.
Input
show debug-log-parameters
Output
Field
host
disk
mem
fo
msg
fca
fcb
fcc
fcd
ioa
iob
ioc
iod
misc
rcm
172 HP StorageWorks 2000 Family Modular Smart Array CLI reference guide • May 2008
This command should only be used by service technicians, or with the
Description
Host interface debug messages
Disk interface debug messages
Internal memory debug messages
Failover/recovery debug messages
Inter-controller message debug messages
FC only. I/O interface driver debug messages (standard)
FC only. I/O interface driver debug messages (resource counts)
FC only. I/O interface driver debug messages (upper layer, verbose)
FC only. I/O interface driver debug messages (lower layer, verbose)
iSCSI and SAS only. I/O interface driver debug messages (standard)
iSCSI and SAS only. I/O interface driver debug messages (resource counts)
iSCSI and SAS only. I/O interface driver debug messages (upper layer,
verbose)
iSCSI and SAS only. I/O interface driver debug messages (lower layer,
verbose)
Internal debug messages
Removable-component manager debug messages