Set Iscsi-Parameters - HP 2000fc Cli Reference Manual

set iscsi-parameters

Description
iSCSI only. Changes system-wide iSCSI parameters.
Input
set iscsi-parameters [chap enabled|disabled] [jumbo-frame
enabled|disabled] [speed auto|1g] [isns enabled|disabled]
[isns-ip iSNS-IP] [isns-alt-ip iSNS-IP]
Parameter
chap enabled|disabled
jumbo-frame
enabled|disabled
speed auto|1g
isns enabled|disabled
isns-ip iSNS-IP
isns-alt-ip iSNS-IP
Example
For a storage system whose host ports are connected to different subnets, enable
CHAP, specify the IP address of the iSNS server on each subnet, and enable
registration with either server.
# set iscsi-parameters chap enabled isns enabled isns-ip
10.10.10.93 isns-alt-ip 10.11.10.90
Description
Enables or disables use of Challenge Handshake
Authentication Protocol. Disabled by default.
Enables or disables support for jumbo frames. Disabled
by default. A normal frame can contain 1500 bytes
whereas a jumbo frame can contain a maximum of
9000 bytes for larger data transfers.
Sets the host port link speed either to auto, which
allows the system to negotiate the proper speed, or to
1 Gbit/sec (1g). The default is auto.
Enables or disables registration with a specified
Internet Storage Name Service server, which provides
name-to-IP-address mapping. Disabled by default.
Specifies the IP address of an iSNS server. The default
address is all zeroes.
Optional. Specifies the IP address of an alternate iSNS
server, which can be on a different subnet. The default
address is all zeroes.
Chapter 3 Command Descriptions 135