Map Volume - HP 2000fc Cli Reference Manual

map volume

Description
Creates a mapping whose settings override a volume's default mapping.
When a volume is created, it has a default mapping that specifies the controller host
ports and access level that all connected hosts have to the volume, and the LUN
presented to all hosts to identify the volume. By default, this mapping presents no
LUN and allows no access for all hosts through all ports. The default mapping's
LUN value is referred to as the volume's default LUN.
Use this command to create mappings with different settings for different hosts.
Optionally, you can specify the LUN, ports, and access level for a mapping. A
mapping can make a volume accessible to hosts, or inaccessible to hosts (known as
masking). For example, assume a volume's default mapping allows read-only access
using LUN 5. You can give one host read-write access using LUN 6, and you can
give a second host no access to the volume at all.
Input
map volume volume [ [lun LUN] | [mapping ports.LUN] ] [host host]
[access read-write|rw|read-only|ro|none]
Parameter
volume
lun LUN
mapping
ports.LUN
94 HP StorageWorks 2000 Family Modular Smart Array CLI reference guide • May 2008
Description
Specifies the volume to map. For the syntax to use, see
"Volume Syntax" on page 26.
Optional if the access parameter is set to none. Specifies the
LUN to assign to the mapping on all ports. If this parameter is
omitted, the default LUN is presented. You cannot use both
this parameter and the mapping parameter.
Optional; unused if the access parameter is set to none.
Specifies the ports through which hosts can access the volume,
and the LUN to assign to the mapping. If not all ports are
specified, the unspecified ports are automatically mapped to no
access. For the syntax to use, see "Volume Mapping Syntax"
on page 27. You cannot use both this parameter and the lun
parameter.