Set Host-Parameters - HP 2000fc Cli Reference Manual

set host-parameters

Description
FC and iSCSI only. Sets parameters for communication between controllers and
hosts. The new settings take effect without restarting the controllers.
Input
set host-parameters [controller a|b|both] [speed speed] [channel
#|all] [fibre-connection-mode loop|point-to-point] [IP address]
[netmask address] [gateway address] [noprompt]
Parameter
controller a|b|both
speed speed
channel #|all
fibre-connection-mode
loop|point-to-point
noprompt
130 HP StorageWorks 2000 Family Modular Smart Array CLI reference guide • May 2008
Description
Optional. Specifies whether to apply the settings to
controller A, B, or both. Required if either speed
or fibre-connection-mode is specified.
Optional. FC only. Sets the link speed in Gbit/sec.
When host port interconnects are enabled, the
speed is also changed for interconnected port on
the other controller. Valid values are 2g and 4g.
Optional. Specifies a host port number. If this
parameter is omitted, all host ports on the specified
controllers are affected.
Optional. FC only. Sets the topology for the
specified channels on the specified controllers to
either:
• loop: Fibre Channel-Arbitrated Loop (public or
private).
• point-to-point: Fibre Channel point-to-
point. Point-to-point topology is only valid and
allowed when port interconnects are disabled
(using set host-port-interconnects).
Optional. Specifies an automatic response to the
confirmation prompt that enables the operation to
proceed. If this parameter is omitted, you must
reply to the prompt.