Using The Cli; Accessing The Cli - HP 2000fc Cli Reference Manual

1
CH A P T E R

Using the CLI

This chapter introduces the HP StorageWorks MSA2000 Family command-line
interface (CLI) and includes the following topics:
"Accessing the CLI" on page 15
■
"Operation Modes" on page 16
■
"Command Syntax" on page 25
■
"Command Completion, Editing, and History" on page 28
■
"Viewing Command Help" on page 29
■
"Size of Devices and Logical Units" on page 29
■
"Event Log" on page 30
■

Accessing the CLI

The CLI software embedded in controller modules enables you to configure,
monitor, and manage a storage system out of band.
You can access the CLI in two ways:
By using a terminal emulator on a management host that is directly connected to
■
a controller module's serial CLI port. See the user guide for information about
setting management port IP addresses using the CLI.
By using
■
host that is remotely connected through a LAN to a controller module's Ethernet
port.
The default usernames and passwords are:
Access Level
Monitor - to monitor system status
Manage - to monitor and manage the system
, an SSH application, or a terminal emulator on a management
telnet
Username Password
monitor !monitor
manage !manage
15