Set Network-Parameters - HP 2000fc Cli Reference Manual

set network-parameters

Description
Sets IP values for controller module Ethernet management ports. IP values can be
set dynamically using Dynamic Host Configuration Protocol (DHCP) for both
controllers, or manually (statically) for each controller.
If DCHP is enabled, manually setting an IP value for either controller disables
DHCP for both controllers.
Input
To set both controllers' IP values dynamically:
set network-parameters dhcp
To set a controller's IP values manually:
set network-parameters [ip address] [netmask netmask]
[gateway gateway] [controller a|b]
Parameter
dhcp
ip address
netmask netmask Optional. Specifies an IP subnet mask.
gateway gateway Optional. Specifies a gateway IP address.
controller a|b
Example
Use DHCP to set Ethernet management port IP values.
# set network-parameters dhcp
Description
Specifies to use DHCP to set both controllers' IP values.
Optional. Specifies an IP address.
Optional. Specifies whether to apply the settings to controller
A or B. If this parameter is omitted, settings are applied to the
controller being accessed.
Chapter 3 Command Descriptions 139