Restore Defaults; Set Debug-Log-Parameters - HP 2000fc Cli Reference Manual

Note –
following event is recorded in the Windows event log: Initiator failed to connect to
the target.
For details see "restart" on page 101.

restore defaults

Note –
advice of a service technician.
Restores the manufacturer's default configuration to the controllers. When the
command informs you that the configuration has been restored, you must restart the
RAID controllers and Management Controllers for the changes to take effect. After
restarting the controllers, hosts might not be able to access volumes until you re-
map them.
Caution –
reconfiguration to restore host access to volumes.
For details see "restore defaults" on page 103.

set debug-log-parameters

Note –
advice of a service technician.
Sets the types of debug messages to include in the Storage Controller debug log. If
multiple types are specified, use spaces to separate them and enclose the list in
quotation marks (
For details see "set debug-log-parameters" on page 122.
254 HP StorageWorks 2000 Family Modular Smart Array CLI reference guide • May 2008
If an iSCSI storage system is connected to a Microsoft Windows host, the
This command should only be used by service technicians, or with the
This command changes how the system operates and might require some
This command should only be used by service technicians, or with the
).
"