To Attach A Disjoint Rollover To A Selected Image - MACROMEDIA FIREWORKS 8-USING FIREWORKS Use Manual

To attach a disjoint rollover to a selected image:

1. Select Edit > Insert > Slice or Hotspot to attach a slice or hotspot to the trigger image.
This step is not necessary if the selected object is a button or if a slice or hotspot
already covers the image.
2.
Create a new frame by clicking the New/Duplicate Frame button in the Frames panel.
3.
Place a second image, to be used as the target, in the new frame in the desired location on
the canvas. You can place the image anywhere other than beneath the slice you created in
step 1.
4.
Select the image, and then select Edit > Insert > Slice to attach a slice to the image.
5.
Select Frame 1 in the Frames panel to return to the frame that has the original image.
6.
Select the slice, hotspot, or button that covers the trigger area (the original image) and place
the pointer over the behavior handle. The pointer changes to a hand.
7.
Drag the behavior handle for the trigger slice or hotspot to the target slice you created in
step 4.
The behavior line extends from the center of the trigger to the upper-left corner of the
target slice, and the Swap Image dialog box opens.
8.
From the Swap Image From pop-up menu, select the frame you created in step 2, and click
OK.
9.
Click the Preview button to preview and test the disjoint rollover.
264 Chapter 11: Slices, Rollovers, and Hotspots