To Undock The Property Inspector; To Dock The Property Inspector At The Bottom Of The Workspace (Windows Only); To Expand A Half-Height Property Inspector To Full Height, Revealing Additional Options; To Collapse The Property Inspector When It Is Docked - MACROMEDIA FIREWORKS 8-USING FIREWORKS Use Manual

The Property inspector can be open at half height, displaying two rows of properties, or at full
height, displaying four rows. You can also fully collapse the Property inspector while leaving it
in the workspace.
Most procedures in Using Fireworks assume that the Property inspector is displayed at
full height.

To undock the Property inspector:

Drag the gripper at the upper left corner to another part of the workspace.
To dock the Property inspector at the bottom of the workspace
(Windows only):
Drag the side bar on the Property inspector to the bottom of the screen.
To expand a half-height Property inspector to full height, revealing additional
options, do one of the following:
Click the expander arrow in the lower right corner of the Property inspector.
Click the icon in the upper right of the Property inspector and select Full Height from the
Property inspector Options menu.
In Windows, the Options menu is available only when the Property inspector is
docked.
To reduce the Property inspector to half height, do one of the following:
Click the expander arrow in the lower right corner of the Property inspector.
Select Half Height from the Property inspector Options menu.
In Windows, the Options menu is available only when the Property inspector is
docked.
To collapse the Property inspector when it is docked, do one of the following:
Click the expander arrow or the title of the Property inspector.
Select Collapse Panel Group from the docked Property inspector Options menu.
For more information about specific Property inspector options, see the appropriate
sections throughout Using Fireworks or Fireworks Help.
32 Chapter 2: Fireworks Basics