Bosch DB18C3100R2 Installation Manual page 59

DiBos/DiBos Micro
2
3
4
5
6
Bosch Sicherheitssysteme GmbH
Time periods
Display
Configure
Camera login
User name:
Password:
Activate alarm input
Name
No.:
Activate relay
Name:
No.:
Activate audio input
Name:
No.:
OK
Installation Guide
Select the time periods for carrying out a reference image
check.
The live image from the selected MPEG4 device will be
displayed if the settings were entered correctly.
After the button is clicked, the configuration of the selected
MPEG4 device is displayed in a browser window.
Enter the user name and password for MPEG4 devices where
they are needed for logging on (e.g. when a user name and
password are configured in the MPEG4 device).
Note:
Select the user name Service, if a service password has been
assigned for the MPEG4 device. The corresponding password
must be entered.
Activate this check box when triggering of the input on the
MPEG4 device is to be used for control of the video system.
Note:
Depending on the type of IP device (e.g. VIP X1600), more
than 1 alarm input can be configured. Select the alarm input
of the MPEG4 device under No. and activate the Activate
alarm input check box for this alarm input.
Enter the name of the alarm input. The choice of name is up
to you.
Choose the alarm input of the selected MPEG4 device.
Activate this check box if the relay output of the MPEG4
device is to be controlled by the video system.
Note:
Depending on the type of IP device (e.g. VIP X1600), more
than 1 relay output can be configured. Select the relay output
of the MPEG4 device under No. and activate the Activate
relay check box for this relay output.
Enter the name of the relay output. The choice of name is up
to you.
Choose the relay output of the selected MPEG4 unit.
Activate this check box when the audio input of the MPEG4
device is to be used.
Enter the name of the audio input.
Choose the audio input of the selected MPEG4 unit.
The entries are saved.
Default Configuration | en
F.01U.033.308 | V7 | 2009.09
59