I/O Card For Dibos - Bosch DB18C3100R2 Installation Manual

24 en | Device Connections
3.1.4

I/O Card for DiBos

The following can be set for the I/O card:
–
–
1
2
NOTICE!
The I/O card must be removed to change the bridge settings.
F.01U.033.308 | V7 | 2009.09
the relay outputs (NO = normally open, NC = normally closed)
the malfunction outputs (NO = normally open, NC = normally closed)
Relay outputs:
The setting is printed on the PCB.
Relay outputs 1–8: open (NO = normally open)
Relay outputs 9–16: closed (NC = normally closed)
Malfunction output:
The setting is printed on the PCB.
Bridge position up:
Open (MAL NO = malfunction normally open)
Bridge position down:
Closed (MAL NC = malfunction normally closed)
Installation Guide
DiBos/DiBos Micro
Bosch Sicherheitssysteme GmbH