Bosch DB18C3100R2 Installation Manual page 126

126 en | Connections
Mapping IP addresses and computer names:
1.
2.
3.
4.
5.
In the router configuration:
1.
2.
3.
NOTICE!
The DSL router and DiBos recorder must be located in the same network.
For the DiBos Receiver
In the configuration of the DiBos receiver:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Mapping IP addresses and computer names:
1.
2.
F.01U.033.308 | V7 | 2009.09
Open the Notepad program.
Enter the public address (Internet address) of the remote station router and the
computer name of the remote station (DiBos receiver). The address and the computer
name must be separated by at least one space or tab character.
Save the file under the file name Imhosts in the directory
C:\WINDOWS\system32\drivers\.
Remove the file extension .txt in Windows Explorer. The file must not have an
extension.
Reboot the computer.
Use the standard configuration of the network provider.
Activate the router's firewall.
Activate port forwarding and forward the UDP port configured in DiBos (e.g. 1750) to the
DiBos recorder IP address (e.g. 192.168.1.10). To do this, use the manufacturer's router
documentation.
Select the Remote stations menu.
Click New and enter the name of the remote station (DiBos recorder).
Enter the public address (Internet address) of the remote station router (DiBos
recorder), e.g. 193.251.9.31.
Select Low bandwidth (live mode) as necessary.
Click OK.
Select the Security and network menu in the configuration.
Select Activate UDP tunneling.
Enter the port number that you have already used in the DiBos recorder (e.g. 1750) under
Port number.
Note:
Check that the port is unused using the netstat -a command.
Click OK.
Open the Notepad program.
Enter the public address (Internet address) of the remote station router and the
computer name of the remote station (DiBos recorder). The address and the computer
name must be separated by at least one space or tab character.
Installation Guide
DiBos/DiBos Micro
Bosch Sicherheitssysteme GmbH