Bosch DB18C3100R2 Installation Manual page 48

48 en | Default Configuration
Entering control commands via the command line
Here, you can specify various commands for dome cameras, pan/tilt cameras or matrix
switches via a command line. These commands can be called up manually or automatically.
The choice of commands available can be found in the operating manual of the respective
camera or matrix switch. The user can quickly select these commands in the live image,
assuming that these have been enabled for his level of authorization.
5
Camera control
The focus and iris can be set for each camera
6
Saving entries
7
F.01U.033.308 | V7 | 2009.09
Camera command line
Save...
Transmit
Delete
Bilinx status:
Iris and focus...
OK
Installation Guide
First line:
The list contains preset control commands that you can
select.
Middle line (command line):
The command that you selected in the first line is displayed.
Alternatively, you can use this line to create a new command
if you do not find a suitable command in the drop-down list
for the first line.
Bottom line:
Assign the command a free number.
Click the button to save. A dialog box opens. Enter a
meaningful name and confirm the entry. A message confirms
that this has been saved.
Note:
The command is available on the user interface.
Click the button to check the command.
The saved command will be deleted.
The status is displayed.
Click the button. A dialog box opens to allow you to set the
iris and focus.
The entries are saved.
DiBos/DiBos Micro
Bosch Sicherheitssysteme GmbH