HEIDENHAIN MANUALPLUS 4110 Manual page 96

Create the "Threaded stud" cycle program
Run the cycle.

Set the feed rate override
feed rate override to 0%

Activate Cycle Start
(The threading tool is not yet
confirmed.)

Confirm tool T8 with the
Tool change key

Activate Cycle Start again

Slowly increase the feed
rate override. The
threading cycle is
performed.
Check the thread and correct the tool, if necessary.
The threading cycle is finished:

Retract with the handwheel

Measure the thread
Thread paths are always machined at the programmed feed rate (thread pitch),
regardless of the current feed-rate override.
HEIDENHAIN MANUALplus 4110 Linear Machining Example 7.30