HEIDENHAIN MANUALPLUS 4110 Manual page 137

Create the ICP contour "Form roll"
Contour element 3 (oblique cut)

Switch to line entry:
Press the Line soft key

Press the Line menu key
Describe the contour element:

Target point X in X: 49.5 mm

Target point Z in Z: –32 mm

Angle A to Z axis: 6°

Length of line L: No entry

Special feed rate F: No entry

Conclude entry:
Press the Save soft key
(There are two solutions.)

Display next solution:
Press the Next solution
soft key
(desired solution)
HEIDENHAIN MANUALplus 4110 Recess Machining Example 9.13