Tool compensation
Add the compensation
value:
Press the Save soft key
(Compensation is activated.
It is shown in the T6 dx field
and in the DX field of the
dialog box.)
Exit the "Tool correct"
function:
Press the Back soft key
Return to program run:
Press the Back soft key
Repeat the finishing cycle with the corrected tool
Position the cursor on the
finishing cycle again:
Press the arrow key
Activate the "Continuous
run" mode:
Press the Continuous run
soft key
(Cycles are run
continuously, without
interruption, up to the next
tool change.)
Repeat the finishing cycle, then run the other cycles
HEIDENHAIN MANUALplus 4110 Executing Programs
11.7