Program The “Threading Cycle” - HEIDENHAIN MANUALPLUS 4110 Manual

Create the "Threaded stud" cycle program
Program the "Threading cycle"

Press the Add cycle soft
key
Select the Threading cycle:

Press the Thread cutting
menu key

Press the Threading cycle
menu key
Enter the cycle parameters:

Starting point X: 16 mm

Starting point Z: 4 mm

End point of thread Z2: –29 mm

Thread pitch F1: 1.5 mm

Thread depth U: No entry

First cutting depth I: No entry

Tool number T: 8

Shaft speed S: 600 m/min
Assume the tool number and technology
data from the tool file (see following
steps).
HEIDENHAIN MANUALplus 4110 Linear Machining Example 7.27